Table of Contents
Advertisement
4
t
h e
C o n t r o l
4.1 f
u n C t i o n s
4.2 m
e n u
Program the QAM module using the buttons on the head-end station control
panel. The menus appear on the two-line display of the control panel.
The parameters and functions to be set are underlined.
With the
You can use the
– Output signal settings:
Modulator on/off, level
Output channel (modulators A and C)
Output frequency (modulators A...D)
QAM modulation
Substitute signal
– Input signal settings:
LNB oscillator frequency
Input symbol rate
Input frequency
Station filter
CA module
Economize descrambling capacity
– Options:
Transport stream and ORGNET-ID
BAT, STD-other
Deleting a PID
Renaming a PID
– Data rate
– Network Information Table (NIT)
– Factory reset
– Save data
p a n e l
a t
o f
t h e
C o n t r o l
S
i t e m s
button select the channel strip / other modules.
button to select the following menu items:
a
g l a n C e
pa n e l
b u t to n s
M
- 12 -
To move the cursor
To adjust values and
functions
To save the programmed
data
To switch to the next
menu
CGS-2 764 C
Advertisement
Table of Contents
