Cisco ASA 5506-X Configuration Manual page 347

Chapter 16 ASA FirePOWER (SFR) Module
•
Additional Guidelines and Limitations
•
•
•
Defaults for ASA FirePOWER
The following table lists the default settings for the ASA FirePOWER module.
Table 16-1
Parameters
Management IP address
Gateway
SSH or session Username
Password
Configure the ASA FirePOWER Module
Configuring the ASA FirePOWER module is a process that includes configuration of the ASA
FirePOWER security policy on the ASA FirePOWER module and then configuration of the ASA to send
traffic to the ASA FirePOWER module. To configure the ASA FirePOWER module, perform the
following steps:
Step 1 Connect the ASA FirePOWER Management Interface, page
management interfaces and optionally, the console interface.
Step 2 (If necessary.)
model with the software module pre-installed.
(If necessary.)
Step 3
required for initial SSH access.
Configure Basic ASA FirePOWER Settings at the ASA FirePOWER CLI, page
Step 4
the ASA FirePOWER module.
(Optional for ASA 5506-X.)
Step 5
This identifies the FireSIGHT Management Center that will manage the device. If you do not configure
a FireSIGHT Management Center for the 5506-X, you can manage the module using ASDM.
For the 5512-X through ASA 5555-X, you must install a Cisco solid state drive (SSD). For more
information, see the ASA 5500-X hardware guide. (The SSD is standard on the 5506-X.)
See Compatibility with ASA Features, page
You cannot change the software type installed on the hardware module; if you purchase an ASA
FirePOWER module, you cannot later install other software on it.
You cannot configure both normal inline mode and inline tap monitor-only mode at the same time
on the ASA. Only one type of security policy is allowed. In multiple context mode, you cannot
configure inline tap monitor-only mode for some contexts, and regular inline mode for others.
ASA FirePOWER Default Network Parameters
Default
admin
Install or Reimage the Software Module, page
Change the ASA FirePOWER Management IP Address, page
Add ASA FirePOWER to the FireSIGHT Management Center, page
16-6.
• System software image: 192.168.45.45/24
• Boot image: 192.168.8.8/24
System software image: none
•
Boot image: 192.168.8.1/24
•
System software image: Sourcefire
•
• Boot image: Admin123
Cisco ASA Series Firewall CLI Configuration Guide
Defaults for ASA FirePOWER
16-8. Cable the ASA FirePOWER
16-11. Skip this step if you purchased a
16-14. This might be
16-15. You do this on
16-16.
16-7