Table of Contents
Advertisement
Installation
3.3.1 Wall mounting with thermo-
well in a different location
The thermostats are fastened to the wall
using two screws (not included in the scope
of delivery).
7. Drill holes in wall as shown in Fig. 3.
8. Insert seal (6).
9. Fix the capillary in the notch at the side
of the thermostat housing or let it run
down the middle (Fig. 4b).
10. Fasten the back of the housing (1) using
two screws to the wall.
11. Screw the thermowell (7) into the pipe
or tank.
12. Push the bulb (2) as far as it will go into
the thermowell (7).
13. Fasten the capillary (3) to the
thermowell (7) using the supplied clip
(7a).
14. Perform electrical connection as de-
scribed in section 4.
15. Screw front cover onto the thermostat.
TR: Place set point adjuster onto the temper-
ature regulator.
Single
thermostat
Fig. 3 · Drill patterns
10
EB 5206 EN
42.4
3.3.2 Mounting on tanks or in
pipes
The thermostats are attached to the
thermowells which are screwed into place.
7. Insert seal (6).
8. Screw thermowell (7) into the pipe or
tank.
9. Insert small metal plate (7b) at the back
of the housing (1) and secure in place
with the screw (7c).
10. Push the bulb (2) as far as it will go into
the thermowell (7), making sure that the
round hole at the back of the housing
(1) rests on the collar on the thermowell.
11. Push the thermostat slightly lengthways
to allow the thermowell to engage.
12. Tighten screw (7c) until the housing is
fixed into place on the thermowell.
13. Perform electrical connection as de-
scribed in section 4.
14. Screw front cover onto the thermostat.
TR: Place set point adjuster onto the temper-
ature regulator.
Double
thermostat
95.4
Advertisement
Table of Contents
