Extension MIB
SNMP Agent MIB access mode
The access mode for MIB in all communities is read only. If you send a GET request for a
SET REQUEST operation, you will receive NoSuchName as a RESPONSE.
Example object identifier system
The following figure shows an example object system supported by SNMP Agent.
Execute snmpwalk as follows to obtain all MIB objects:
1. Specify object identifier 1.3.6.1.2.1 to obtain the information shown in 1.
2. Specify object identifier 1.3.6.1.4.1.116 to obtain the information shown in 2.
MIB mounting specifications supported by SNMP Agent
SNMP Agent supports two MIB mounting specifications.
The supported MIB mounting specifications are as follows:
mgmt OBJECT IDENTIFIER ::= {iso(1) org(3) dod(6) internet(1) 2 }
■
mib-2 OBJECT IDENTIFIER ::= {mgmt 1}
■
MIB
tcp group
udp group
egp group
snmp group
Chapter 7: SNMP supported MIBs
Hitachi Alert Notification Guide for VSP5000 Series
SNMP Agent MIB access mode
Supported?
No
No
No
No
Yes
45