Network; Factory Default - Canon LV-WU360 User Manual

Advanced

Network

Preparation
1 Required equipment: Projector, computer, network cable
2 Connection:
Connect your projector to a router or switch in the LAN with normal or jumper network
cable. In case a normal network cable failed to connect successfully, use a jumper cable
instead.
3 Turn on the computer. The LAN port on computer and projector are flashing after power
on the projector.
Operation steps
1 Power on your projector.
2 Acquire the IP address, with DHCP set to on and
auto IP allocation set to On. (You may set DHCP
to Off and set up IP address manually.)
3 Enter the network setup menu
(1) Press MENU button on remote controller or
top control panel, press
network icon.
(2) Press button select network settings and
press OK button to enter.
MAC address......Display the MAC address
IP address...........Display the IP address of
(3) Press button to set DHCP On to obtain
an IP address, subnet , gateway and DNS
automatically , and press OK button to
confirm.
Press button to set DHCP Off,then
press OK button to enter an IP address,
then press button to select subnet ,
gateway and DNS automatically.And press
OK button to confirm.

Factory default

This function resets all your settings to factory default .
1) Press button to select [Factory default] menu.
2) Press <OK or > button.
3) Press button to select YES ,then press <OK>
button.
button to select
of wired network.
wired network.
72
Network menu
Advanced
Network
Network setting
Network information
MAC address:
IP address
LAN
DHCP
IP address
Subnet
Gateway
DNS
：Adjust OK ：Next
LAN
DHCP
IP address
192
Subnet 255
Gateway
192
DNS
192
：Adjust OK ：Next
Return to factory default?
Yes No
：Move OK ：Select
7C:6F:F8:4E:B9:2F
192.168.1.100
Network setting
On
. . .
. . .
. . .
. . .
Set Cancel
MENU ：Back
Network setting
Off
. 168 . 1 . 100
. 255 . 255 . 0
. 168 . 1 . 1
. 168 . 1 . 1
Set Cancel
：Back
MENU
：Back
MENU