PROGRAMMING MODE
1. Programming mode
You can check machine information or change setting on Program setup or Diagnostic test.
There are two methods that you can enter programming mode.
■ how to enter "Programming mode"
You can enter programming mode only for Idle state
and pause state.
- Card Type
1) Insert service card.
2) Display will show
- Coin Type
1) Dissemble upper coin box key.
2) Take out the coin drop from the coin box.
3) Turn on/off the toggle switch at the back of the coin
box.
4) Display will show "
- OPL/Coin Type
1) Push the High Temp. and Low Temp. button at the
same time.
2) Push the Med Temp. button 3 times.
3) Push the Start button.
4) Display will show "
Coin Box Key
Coin Vault
Coin type
NOTE
• If you turn on the power without connecting the meter case for the first time, the machine will display
• When the machine comes from the factory, it is set in the coin type. You can change Card/Coin type by button.
(For more information refer to SETUP mode's
• The machine will display "PUSH" for OPL type
".
"
Insert debit card
Card type
PROGRAMMING MODE
■ how to use button
You can change Dryer vend price, cycle time and Cycle
parameters, etc.
Press button
High Temp.
Med Temp.
Low Temp.
No Heat
Start
/
.)
description
Move to upper level
Move to the mode in the
same level (+)
Move to the modes in the
same level (-)
-
Enter the selected mode
OPL type
15
.