Table of Contents
Advertisement
A40B
Instruction Manual
Preparing for Operation
This section of the manual describes how to unpack and prepare the Current Shunts for
operation.
Unpacking and Inspecting the Shunts
The coaxial Current Shunts are robust when handled correctly by their
ends. Take care not to damage the horizontal struts of the coaxial shunts.
Upon receiving the Current Shunts from the carrier, carefully unpack and inspect them
for damage. If there is any sign of physical damage, notify the carrier immediately.
As part of the inspection process, check the contents against the list shown in Table 1.
Report any shortages to the nearest Fluke Technical Service Center. See Contacting
Fluke.
Save the container and any packing material for future use in storing or shipping the
Current Shunts
A40B-Case ............................................. Transit/storage case for the A40B Current Shunts
Packing List of Items............................. Includes the serial number of the Current Shunts
Current Shunts
one boxed active shunt with battery charger ...... 1 mA
three boxed passive shunts................................ 10 mA, 20 mA 50 mA
five small size coaxial shunts ............................. 100 mA, 200 mA, 500 mA, 1 A, 2 A
three medium size coaxial shunts ...................... 5A, 10 A, 20 A
two large size coaxial shunts.............................. 50 A, 100 A
Connector Adapters
A40B-ADAPT/LC................................. LC Male to LC Male adapter
A40B-ADAPT/LCN ............................. LC Female to N Male inter-series adapter
A40B-LEAD/N ..................................... N Male to N Male lead
A40B-LEAD/4mm ................................ N to 4 mm double banana connector
Battery charger for 1 mA active shunt
CD containing the Instruction Manual (PDF)
Accessories
The LC and N adapters described in Table 2 are available as accessories:
Accessory
A40B-CAL/LC
A40B-CAL/N
8
Note
Table 1. Contents of the Current Shunt Set Packaging
Description
Table 2. A40B Accessories
High current adapter to connect two shunts in series for measurement (LC to LC)
Low current adapter to connect two shunts in series for measurement (N to N)
Description
Quantity
1
1
14
1
1
1
2
1
1
Advertisement
Table of Contents
