Pioneer VSX-94TXH Service Manual page 14

1
QQ
3 7 63 1515 0
A 7 TV CONTROL buttons
These buttons are dedicated to control the TV assigned to
the TV CTRL button. Thus if you only have one TV to hook
up to this system assign it to the TV CTRL input source
button. If you have two TVs, assign the main TV to the TV
CTRL button.
TV – Use to turn on/off the power of the TV.
TV VOL +/– – Use to adjust the volume on your TV.
INPUT SELECT – Use to select the TV input signal.
TV CH +/– – Use to select channels.
8 Component control buttons
The main buttons (,, etc.) are used to control a
B
component after you have selected it using the input
source buttons.
The controls above these buttons can be accessed after
you have selected the corresponding input source button
(for example DVD,DVR1 or TV). The following controls
can be accessed when listening to the built-in tuner:
MPX – Switches between stereo and mono reception
of FM broadcasts. If the signal is weak then switching
to mono will improve the sound quality.
DISP – Switches between named station presets and
radio frequencies.
C
9 STATUS
Press to check selected receiver settings.
10 MULTI OPE
Use this button to perform multi operations.
TE
11 SHIFT
L 13942296513
Press to access the controls outlined in white boxes (for
example, INPUT SELECT
selected input source in the remote control LCD.
12 SOURCE
Press to turn on/off other components connected to the
receiver.
D
13 Character display (LCD)
This display shows information when transmitting
control signals.
The following commands are shown when you're setting
the remote to control other components:
SETUP – Indicates the setup mode, from which you
choose the options below.
PRESET
LEARNING
MULTI OP
SYS OFF
E
www
F
14
1
http://www.xiaoyu163.com
2
), or to display the currently
x ao
y
. i
VSX-94TXH
2
http://www.xiaoyu163.com
3
8
DIRECT F
RENAME
ERASE
RESET
READ ID
14 RECEIVER
Switches the remote to control the receiver (used to
select the green commands above the number buttons
(ANALOG ATT, etc.). Also use this button to set up
surround sound. With SHIFT, this selects the MULTI-ZONE
control, shown in the display as RCV/Z2,RCV/Z3.
15 VOL +/–
Use to set the listening volume.
16 MUTE
Mutes the sound or restores the sound if it has been
muted (adjusting the volume also restores the sound).
17 Receiver controls
SIGNAL SEL – Use to select an input signal.
SBch – Use to select the surround/virtual back
channel mode.
STEREO/F.S.SURR – Switches between the stereo
playback mode and the Front Stage Surround
Advance mode.
THX – Press to select a Home THX listening mode.
STANDARD – Press for Standard decoding and to
switch between the various
Neo:6 options.
Q Q
3 6 7 1 3
ADV.SURR – Use to switch between the various
surround modes.
18 PHASE – Press to switch on/off Phase Control or Full
Band Phase Control.
MCACC – Press to switch between MCACC presets.
S.DIRECT – Press to select Auto Surround or Stream
Direct listening.
u163
.
3
4
2 9 9 4 2 8
Pro Logic IIx and
1 5 0 5 8 2 9 9 4
m
co
4
9 9
2 8 9 9