Setting An Indoor Unit Address And Installation Option - Samsung AM050FNKDEH User & Installation Manual

Setting an indoor unit address and installation option

Set the indoor unit address and installation option with remote controller option.
Set the each option separately since you cannot set the ADDRESS setting and indoor unit installation setting option at the same
time. You need to set twice when setting indoor unit address and installation option.
The procedure of option setting using wireless remote controller
MR-DC00, MR-DH00
Entering mode for
option setting
High Temp Button
Low Temp Button
❋ The display of the remote controller may be different depending on the model.
Step 1. Entering mode to set option
1. Remove batteries from the remote controller.
2. Insert batteries and enter the option setting mode while pressing High Temp button and Low Temp button.
3. Check if you have entered the option setting status.
Step 2. The procedure of option setting
After entering the option setting status, select the option as listed below.
Option setting is available from SEG1 to SEG 24
SEG1 SEG2 SEG3 SEG4 SEG5 SEG6 SEG7 SEG8 SEG9 SEG10 SEG11 SEG12
0
SEG13 SEG14 SEG15 SEG16 SEG17 SEG18 SEG19 SEG20 SEG21 SEG22 SEG23 SEG24
2
MR-EC00, MR-EH00
Entering mode for
Option setting mode
option setting
Mode change
High Fan Button
High Temp Button
Low Fan Button
Low Temp Button
1
3
Option setting mode
On(SEG1~12) Off(SEG13~24)
Mode change
High Fan Button
Low Fan Button
49