Program Mode; Quick Start Wizard Via The Ldi Push Buttons - Siemens SITRANS LR560 Quick Start Manual

PROGRAM mode

Using the LDI push buttons, press
through the menu using
To edit a number
Note: With the Enter icon
the right-most digit,
1) Navigate to the desired parameter, for example, Low Calibration
point (2.3.1), and press
be highlighted.
2) Press or to delete the highlighted value.
3) With the Enter icon highlighted
4) Use or to modify the highlighted digit. Scroll past 9 to
reach the decimal point.
5) Press to select and highlight the plus or minus sign. Press
6) Press until the Enter icon is highlighted
7) When the value is complete, press
to accept the value.
To modify a text string:
1) Navigate to the parameter you wish to modify and press
highlighted.
2) Follow the same steps as above, to add, delete, or modify characters.

Quick Start Wizard via the LDI push buttons

1. Quick Start
Note: Default values are indicated by an asterisk (*) in the tables below, unless explicitly
described.
1.1. Quick Start Wizard
1) Press twice to navigate to Quick Start (1.) and open
Quick Start Wizard (1.1.)
2) At each step, press
directly to the next item,
or to open Edit mode: the current selection is
highlighted.
3) Scroll to desired item and press
4) At any time, you can press
Measurement mode.
7ML19985XQ81 SITRANS LR560 (PROFIBUS PA) – QUICK START MANUAL
to enter Program Mode and open menu level 1. Scroll
, , , .
highlighted, press
to accept the value, or
twice to open and edit it. The value will
, press
until the Enter icon is highlighted
to accept default values and move
to go back, or
to insert a digit on the right,
to cancel.
to add a digit.
, then press
to edit it. The string will be
to store the change, then press
to cancel and return to
to delete
or to change it.
to add a digit on the right.
, then press
to continue.
Page EN-11