Star Micronics NX-2400 User Manual page 79

Perform one n/180-inch or n/2164nch line feed
Mode ASCII
Decimal Hexadecimal
Both <ESC>
"J"
n
27 74
n
lB4A
n
Feeds the paper once by n/180 inches (Standard mode) or
n/216
inches
(IBM mode), where n is between 0 and 255. Does not move the print
position right or left when DIP switch l-2 is OFF; returns the carriage
to the left margin if DIP switch l-2 is ON. Does not change the
line-spacing setting.
Perform one n/780-inch
reverse
line feed
Mode ASCII
Decimal
Hexadecimal
Std.
< ESC > 'j" n
27 106
n
IB6A n
Feeds the paper once by n/180 inches in the reverse direction, where n
is between 0 and 255. Does not move the print position right or left when
DIP switch l-2 is OFF; returns the carriage to the left margin if DIP switch
l-2 is ON. Does not change the line-spacing setting. Ignored when friction
feed is used.
Feed paper n lines
Mode ASCII
Decimal
Hexadecimal
<ESC> "f' "1"
n
27 102 49
n
1B 66 31
n
Both -
<ESC>
"f' cl>
n
27 102 1
n
1B 66 01
n
Feeds the paper
n
lines from the current line, where n is between 0 and
127.
Set top of page at current position
IModel ASCII 1 Decimal 1 Hexadecimal
I
IIBM I <ESC>
"4" 1 27 52 IIB 34
I
Sets the current position as the top-of-page position. Note that this can
also be done from the control panel.
Set page length to n lines
I Mode I ASCII
I
Decimal
I
Hexadecimal
I
IBoth I
cESC> "C"
n
I 27 61 n IlB 43
n
I
Sets the page length to II lines in the current line spacing, where n is between
1 and 127 in Standard mode or between 1 and 255 in IBM mode. Changing
the line spacing later does not alter the physical page length. The current
line becomes the top of the page.
71