Fiat 500 L 2019 User Manual page 69

Enhanced Accident Response System Reset
Procedure
After the event occurs, when the system is active,
a message regarding fuel cutoff is displayed. Turn
the ignition switch from ignition AVV/START or
MAR/ACC/ON/RUN to ignition STOP/OFF/
LOCK. Carefully check the vehicle for fuel leaks in
the engine compartment and on the ground near
the engine compartment and fuel tank before
resetting the system and starting the engine.
Depending on the nature of the event the left
and right turn signal lights, located in the instru-
ment panel, may both be blinking and will con-
tinue to blink. In order to move your vehicle to
the side of the road, you must follow the system
reset procedure.
Customer Will See
NOTE:
Customer Action
Each step MUST BE
held for at least two
seconds
1. Turn ignition STOP/
OFF/LOCK. (Turn Sig-
nal Switch Must be
placed in Neutral
State).
Customer Will See
NOTE:
Customer Action
Each step MUST BE
held for at least two
seconds
Right turn light
2. Turn ignition MAR/
BLINKS.
ACC/ON/RUN.
Left turn light is OFF.
Right turn light is ON
3. Turn right turn signal
SOLID.
switch ON.
Left turn light BLINKS.
4. Place turn signal in Right turn light is OFF.
neutral state. Left turn light BLINKS.
Right turn light
5. Turn left turn signal BLINKS.
switch ON. Left turn light is ON
SOLID.
Right turn light
6. Place turn signal in
BLINKS.
neutral state.
Left turn light is OFF.
Right turn light is ON
7. Turn right turn signal
SOLID.
switch ON.
Left turn light BLINKS.
8. Place turn signal in Right turn light is OFF.
neutral state. Left turn light BLINKS.
Customer Will See
NOTE:
Customer Action
Each step MUST BE
held for at least two
seconds
Right turn light is ON
9. Turn left turn signal SOLID.
switch ON. Left turn light is ON
SOLID.
10. Turn left turn signal
switch OFF. (Turn Sig-
Right turn light is OFF.
nal Switch Must be
Left turn light is OFF.
placed in Neutral
State).
11. Turn ignition STOP/
OFF/LOCK.
12. Turn ignition MAR/
ACC/ON/RUN. (Entire
sequence needs to be System is now reset
completed within one and the engine may be
minute or sequence started.
will need to be re-
peated).
Turn hazard flashers
OFF (Manually).
67