11. Attach cover with screws, General Grinder Installation sleeves and washers provided. Information Instructions 12. Power, control cords, pressure tubing (for PCP units only) 1. Remove existing pump and Attention: This manual and high water alarm to be pipe system. contains important information for routed through junction box.
Page 3
Float Control Pressure Control Semipositive Displacement Pump Centrifugal Pump (HPD200) (HPGR200)
Page 4
Retrofit Pressure Level Control Junction Box Wiring Diagram Part No. 27480A300 Part No. 27480A200 Incoming 12/6 Power Cord Incoming 12/2 or 14/2 Power Cord Terminal Label Terminal Label Retrofit Float Level Control Junction Box Wiring Diagram Part No. 27480A104 Incoming 12/6 Power Cord Incoming 14/2 Power Cord Terminal Label...
Page 6
Pressure Control Retrofit System Replacement Parts HPD200 Pressure Control System Shown VALVE 45° PUMP NOTE: CHECK VALVE MUST BE NOTE: SHIPPED LOOSE IN CARTON FOR INSTALLED PER OPTIONAL CUSTOMER INSTALLATION ILLUSTRATION ORDERING REPLACEMENT PARTS: Product improvements are made from time to time. The latest part design will be furnished as long as it is interchangeable with the old part.
Page 7
Float Control Retrofit System Replacement Parts HPGR200 Float Control System Shown VALVE 45° PUMP NOTE: CHECK VALVE MUST BE INSTALLED PER NOTE: SHIPPED LOOSE IN CARTON FOR ILLUSTRATION OPTIONAL CUSTOMER INSTALLATION HPD200 only ORDERING REPLACEMENT PARTS: Product improvements are made from time to time. The latest part design will be furnished as long as it is interchangeable with the old part.
Page 8
Pentair Hydromatic will cover only the lower seal and labor thereof for all dual seal pumps. under no circumstance will Pentair Hydromatic be responsible for the cost of field labor, travel expenses, rented equipment, removal/reinstallation costs or freight expenses to and from the factory or an authorized Pentair Hydromatic service facility.