Anti-Fouling - Raymarine HYPERVISIONT HV-300 Series Installation Instructions Manual

Item Description
1 Band saw (with table tilt)
2 Digital angle finder (if dead rise angle identification is required.
Warning: Marine-grade sealant
Only use marine-grade neutral cure polyurethane sealants. Do NOT use sealants
containing acetate or silicone, which can cause damage to plastic parts.

Anti-fouling

Where local regulations allow, it is recommended that you coat your transducer using a water-based
anti-fouling paint. This will help prevent the build-up of organic growth, which can reduce transducer
performance.
Important:
• Before applying water-based anti-fouling paint, check that local environmental rules and
regulations do not prohibit the use of anti-fouling paint.
• Never use copper-based anti-fouling paint as this can impact transducer performance.
• Never use ketone-based anti-fouling paint as this can attack the transducer's plastic, damaging
the transducer.
• Paint your transducer using a brush, do not use a spray can or a sponge roller as these methods
can cause tiny air bubbles to be incorporated in the paint, which will also reduce transducer
performance.
Installation 19