Stamina 55-1539A Owner's Manual page 9

ASSEMBLY INSTRUCTIONS
Buckle
1.
2.
Buckle
STEP 7
Install the HEIGHT ADJUSTMENT BEAM(12) into MAIN FRAME(4) by pulling the SPRING PIN(22) on the
MAIN FRAME(4) and inserting the HEIGHT ADJUSTMENT BEAM(12) as shown. For added safety, thread
the SECURING KNOB(23) into the back side of the MAIN FRAME(4).
WARNING: Do not use the Therapy Inversion System until you have verified your height setting. Failure
to use the proper height setting can result in difficulty recovering from the decline position. See
HEIGHT ADJUSTMENT instructions on page 11.
STEP 8
Attach the NYLON STRAP(31) onto the BUCKLE on the end of the BUCKLE STRAP(32) by inserting the
end of the strap up through the bottom of the buckle, as shown in the illustration 1.
STEP 9
Hook the end of the NYLON STRAP(31) onto the loop on the back of the MAIN FRAME(4). Hook the end of
the BUCKLE STRAP(32) onto the loop on the FRONT FRAME(1).
NOTE: The NYLON STRAPS are used to control the decline angle of the Therapy Inversion System. For
a steeper decline angle, lengthen the straps. For a lessor decline angle, shorten the straps. Make sure
these NYLON STRAPS are tight in the buckle and check the decline angle before using the Therapy
Inversion System.
A.
B.
C.
9