Stamina fusion 15-7250 Owner's Manual page 19

COMPUTER INSTRUCTIONS
COMPUTER OPERATION
STEP 1: POWER ON
Pedaling or press any button.
STEP 2 : SELECT PROGRAM
Select and press one of the PROGRAM BUTTONS to enter the desired program.
STEP 3: SET THE PROGRAM TIME OR CALORIE (and input age for Heart Rate Control Programs)
The TIME function mode will appear with the display flashing "0:00". You have options to do the following:
1. Press START / STOP button to start the program. All of the function values will count up from zero.
2.
Use " / " buttons to set the program time, from one minute up to 99 minutes with 1 minute increments.
Or, you can keep TIME as "0:00" and press the ENTER button to enter the mode to set the CALORIE.
Use " / " buttons to set the CALORIE, from 10 Kcal. up to 9990 Kcal. with 10 Kcal. increments. Press
the ENTER button to confirm the setting. Press the START / STOP button to start the program.
When you select the Heart Rate Control Programs, P11 or P12, you must input your age. Press ENTER
button until the AGE/TARGET H.R. display is flashing and use " / " buttons to input your age. Press the
ENTER button to confirm the setting. Press the START / STOP button to start the program.
1. The program will not start until you press the START / STOP button.
NOTE:
2. The computer will count down from the function values that you set, Time and Calorie. When
one of the two function values counts down to zero, the computer will remind you with an
audible alarm and start counting up this function value. Another function value will continue to
count down.
3. If you don't set the program time, the computer will count up from one second up to 99:59
minutes, and use the default workout time, 30 minutes, to cycle run the program profile.
OPERATION DESCRIPTIONS
1. To stop a running program, press the START / STOP button. In this mode, you can press the
START / STOP button again to continue to run the current program. Or, you can use the PROGRAM
BUTTONS to select a new program. The function values of DISTANCE and CALORIE will continue to
accumulate.
2. When you complete a program, press the START / STOP button to stop the program. You can use the
PROGRAM BUTTONS to select a new program. The function values of DISTANCE and CALORIE will
continue to accumulate. This will allow you to run several programs and still know the total DISTANCE
and CALORIE during the workout.
3. If you want to restart with a new program, press and hold the START / STOP button down for four
seconds to reset all of the function values to zero. Use the PROGRAM BUTTONS to select a new
program.
4. The computer will shut off automatically after 4 minutes of inactivity, and the function values, DISTANCE
and CALORIE, will be kept.
POWER SOURCE:
The computer uses the ADAPTER(105) as a power source. Use the Magnetic Fusion 7250 Bike with the
adapter plugged into an electrical outlet.
19