System; Stp - TRENDnet TI-PG541i User Manual

TRENDnet User's Guide
Default Settings:
STP/RSTP:
STP/RSTP mode:
Forward Time:
Hello Time:
Maximum Age:
System Priority:
Transmission Limit:
Per port STP state:
Per port Priority:
Per port Edge port:
Per port BPDU filter:
Per port BPDU guard:
Per port BPDU Root guard:
Per port Path Cost:
Example: Bandwidth ->
10 Mbps ->
100 Mbps ->
1 Gbps ->
10 Gbps ->
CLI Configuration
Node Command
enable show spanning-tree active
© Copyright 2019 TRENDnet. All Rights Reserved.
disabled.
RSTP.
15 seconds.
2 seconds.
20 seconds.
32768.
3 seconds.
enabled.
128.
disabled.
disabled.
disabled.
disabled.
depend on port link speed.
STP Port Cost Value
100
19
4
2
Description
This command displays the
spanning tree information for only
active port(s)
enable show spanning-tree blockedports
show spanning-tree port detail
enable
PORT_ID
show spanning-tree statistics
enable
PORT_ID
enable show spanning-tree summary
enable clear spanning-tree counters
clear spanning-tree counters
enable
PORT_ID
configure spanning-tree (disable | enable)
spanning-tree algorithm-timer
configure forward-time TIME max-age
TIME hello-time TIME
no spanning-tree algorithm-
configure
timer
spanning-tree forward-time <4-
configure
30>
configure no spanning-tree forward-time
configure spanning-tree hello-time <1-10>
Industrial Managed Switch Series
This command displays the
spanning tree information for only
blocked port(s)
This command displays the
spanning tree information for the
interface port.
This command displays the
spanning tree information for the
interface port.
This command displays the
summary of port states and
configurations
This command clears spanning-tree
statistics for all ports.
This command clears spanning-tree
statistics for a specific port.
This command disables / enables
the spanning tree function for the

system.

This command configures the
bridge times (forward-delay,max-
age,hello-time).
This command configures the
default values for forward-time &
max-age & hello-time.
This command configures the
bridge forward delay time (sec).
This command configures the
default values for forward-time.
This command configures the
bridge hello time(sec).
82