Table of Contents
Advertisement
Place the flat top of the blade against the skin and slowly slide through the hair against
the direction of growth.
TRIMMING AND EDGING
1. Hold the groomer with the back side of the blade facing you with no combs
attached.
2. Start with the blades resting lightly against your skin, use motions towards edge of
beard line to trim to desired locations in facial area.
3. Shape as desired.
Trimming with shaving gel
Follow the same instructions as dry shaving if using shaving gel.
Caution: After use with shaving gel, please rinse the blade under warm water to clean
away any excess gel and debris.
CARE OR YOUR GROOMER
To ensure long lasting performance of the groomer, clean after each use.
The easiest and most hygienic way to clean the groomer is by rinsing the head under the
tap after use while the blades are running.
To keep the unit in optimal condition we recommend re-oiling the blades after cleaning.
Place a few drops of cutter or sewing machine oil onto the blades. Wipe off excess oil.
BATTERY REMOVAL
The battery must be removed from the appliance before it is scrapped.
The appliance must be disconnected from the supply mains when removing the battery.
1. Ensure the trimmer is discharged of all power.
2. Remove the comb attachment.
3. Detach the blade head.
4. Pry off the bottom gap below the grips.
5. Press in exposed tabs and pull internal frame out.
6. Disconnect the battery from the circuit board and internal frame.
7. The battery is to be disposed of safely.
5
Advertisement
Table of Contents
