Table of Contents
Advertisement
INSERTING/REPLACING THE BATTERY
1. Your trimmer requires 1 'AAA' alkaline battery (included).
2. Open the arms of the device so that you can access the battery compartment.
3. Remove the battery compartment cover by pressing the tab (fig. A).
4. Fit the battery with the polarity as shown (fig. B).
5. Replace the battery compartment cover.
INSTRUCTIONS FOR USE
The trimmer gently removes unwanted hair and is ideal for use on the face, neckline,
beard and other small areas.
1. The trimmer will automatically switch on as you open the arms past about 90º. The
operating range is shown in figure C. It will stop when you fold the arms together
again.
BEARD MAINTENANCE
1. Use the trimer without the comb fitted for edging and contouring the beard.
2. Use with the comb fitted for length trimming and maintenance.
TO TRIM UNWANTED HAIR
1. Hold the trimmer against the skin and apply gentle pressure.
2. Trim with and against the direction of hair growth to get the best results.
TO TRIM THE LENGTH OF THE EYEBROWS
1. Remove the comb from its storage compartment.
2. Slide the comb over the trimming head.
3. Select the desired length (3 or 5 mm) using the two slots on the side of the comb (fig. D).
TO SHAPE THE EYEBROWS
1. Hold the trimmer at a right angle to your skin and press down gently.
2. Edge and shape the area as desired.
CAUTION
•
Do not apply excessive pressure, doing so may damage the trimmer head or result in
skin injury.
4
Advertisement
Table of Contents
