Remington G2 Graphite Series Quick Start Manual page 6

3. Hold the clipper with the blade teeth pointing upwards. Begin starting at the centre
of the head at the base of the neck.
4. Slowly lift the clipper, working upwards and outwards through the hair, trimming
just a little at a time.
Step 2: Back of the head
• With the comb set at 12 mm or 18 mm, cut the hair at the back of the head.
Step 3: Side of the head
1. Adjust the comb to a shorter length setting for the areas around the ears.
2. Increase the length setting on the adjustable comb to gradually transition the length
of hair on the side of the head to the longer hair on the top of the head.
Step 4: Top of the head
1. Adjust the comb to the longer length settings (up to 20 mm) then cut the hair on top
of the head against the direction in which the hair normally grows.
2. Always work from the back of the head.
Trim the sideburns
• To trim the sideburns, adjust the comb to the desired length setting, or use one of
the fixed guide combs.
SHORT/LONG BEARD TRIMMING
Attachments
Wide trimmer with adjustable comb
1. Fit the wide trimmer and adjustable comb.
2. Set the adjustable comb to the desired length.
3. Start trimming under the chin following the line of the jaw.
4. Work upwards towards the ear and upper beard line.
CONTOUR EDGING AND CLOSE HAIR CUTTING
Attachments
Wide trimmer
Contour edging:
1. Hold the device with the cutting blade (teeth) facing you and at 90 degrees to the
skin.
2. Start with the edge of the beard/moustache line and, with the blade resting lightly
against the skin, use slow controlled movements to create contoured lines.
6