Basic Configuration With The Wizard - Siemens SIMATIC NET SCALANCE WLC711 Getting Started

Basic configuration with the wizard

Introduction
After you log on the first time, the WBM provides you with a wizard for the basic
configuration of the WLC.
You can call up the wizard at any time using the "Wireless Controller > Installation Wizard"
menu command.
Note
Reconfiguration of the network topology with the wizard is not possible.
You cannot reconfigure the network topology with the wizard, but only configure following a
system reset. You can only modify the network topology later using the "Wireless Controller
> Topologies" menu command.
SCALANCE WLC711
Getting Started, 04/2016, C79000-G8976-C269-07
4
23