Service - Lennox LCH Series Installation Instructions Manual

Service

The unit should be inspected once a year by a qualified
service technician.
CAUTION
Label all wires prior to disconnection when servic­
ing controls. Wiring errors can cause improper and
dangerous operation. Verify proper operation after
servicing.
A-Filters
Units are equipped with temporary filters which must be
replaced prior to building occupation. See table 38 for
correct filter size. Refer to local codes or appropriate
jurisdiction for approved filters.
WARNING
Units are shipped from the factory with temporary
filters. Replace filters before building is occupied.
Damage to unit could result if filters are not re­
placed with approved filters. Refer to appropriate
codes.
Approved filters should be checked monthly and
replaced when necessary. Take note of air flow direction
marking on filter frame when reinstalling filters. See
figure 30.
UNIT FILTERS
Unit
036S, H; 048S, H
036U; 048U;
060S, H, U; 072H, 074U
NOTE-Filters must be U.L.C. certified or equivalent for
use in Canada.
LGH/LCH036, 048, 060, 072, 074
TABLE 38
Qty Filter Size - inches (mm)
4 16 X 20 X 2 (406 X 508 X 51)
4 20 X 20 X 2 (508 X 508 X 51)
B-Lubrication
All motors are lubricated at the factory. No further
lubrication is required.
C-Burners (Gas Units)
Periodically examine
appearance during the heating season. Before each
heating season examine the burners for any deposits or
blockage which may have occurred.
Clean burners as follows:
1- Turn off both electrical power and gas supply to unit.
2- Remove blower access panel.
3- Remove top burner box panel.
4- Remove screws securing burners to burner support
and lift the individual burners or the entire burner
assembly from the orifices. See figure 31 or 32. Clean
as necessary.
5- Locate the ignitor under the right burner. Check
ignitor spark gap with appropriately sized twist drills
or feeler gauges. See figure 33.
6- Replace burners and screws securing burner. See
figure 34 or 35.
Danger of explosion. Can cause injury or
death. Do not overtighten main burner
mounting screws. Snug tighten only.
7- Replace access panel.
Page 67
REMOVE FILTERS
FIGURE 30
burner flames
WARNING
PULL TO
REMOVE
FILTERS
for proper