Miele KM 6629-1 Operating And Installation Instructions page 78

Installation
Disconnecting from the mains

Risk of electric shock.
There is a risk of electric shock if the
appliance is connected to the mains
supply during repair or service work.
After disconnection, ensure the ap-
pliance cannot be switched back on
by mistake.
To disconnect the appliance from the
mains power supply, do one of the fol-
lowing depending on installation:
Safety fuses
 Completely remove fuses.
Automatic circuit breakers
 Press the (red) test button until the
middle (black) button springs out.
Built-in circuit breakers
 Circuit breakers at least type B or C:
Switch the lever from 1 (on) to 0 (off).
Residual current device (RCD)
 Switch the main switch from 1 (on) to
0 (off) or press the test button.
78
Mains connection cable
The hob must be connected to the elec-
trical supply with a special connection
cable, type H 05 VV-F (PVC insulated)
with a suitable diameter.
Please see wiring diagram for connec-
tion. (N.B. This appliance is supplied
single phase only in the UK / AUS / NZ).
See the data plate on the hob for the
correct voltage and frequency.
Replacing the mains connection
cable

Risk of electric shock.
Incorrect connection to the power
supply may result in an electric
shock.
The mains cable must only be re-
placed by a qualified electrician.
When replacing the mains cable only
use cable type H 05 VV-F with a suit-
able cross section. A suitable connec-
tion cable is available to order from
Miele.