Table of Contents
Advertisement
• +48V setting
• Audio codec mode setting
For details on the transmitter settings, see "Changing the
Settings on the Transmitter" on page 17.
Cancelling the Cross Remote
In the TX1/2 menu, select RF REMOTE, and then OFF.
Notes on the Cross Remote
The wireless remote control function on the receiver uses
the 2.4 GHz band and may thus be subject to interference
from other devices.
• When pairing fails ("Pairing fail" is displayed), carry out
pairing again. Successful communication between the
transmitter and the receiver has not occurred within a
given amount of time. Pairing may be harder to do when
another receiver is engaged in pairing nearby.
• When it becomes hard to use the remote control, the
remote control may be improved by switching the
wireless remote control function off, then on again in the
RF REMOTE display, then re-pairing with the
transmitter (change to a channel with less interference).
Changing the Settings on
the Transmitter
For details on menu operation, see "Basic Menu
Operations" on page 11.
You can change the settings on the transmitter that is
paired with this receiver using the RX1/2 menu or the
TX1/2 menu.
The following shows the US model display.
Receiver
Group/Channel Setting
This setting is set through the GP/CH indication of the
RX1/2 menu.
For details, see "Selecting the Frequency Band / Group /
Channel" on page 6.
Frequency Band Setting
This setting is set through the BAND screen of the RX1/
RX2 menu.
For details, see "Selecting the Frequency Band / Group /
Channel" on page 6.
Transmission Power Setting
You can change the transmission power of the transmitter.
Note
Always perform pairing after changing the maximum RF
output power setting for a transmitter. If you fail to do so,
configuration of RF output power settings via the wireless
remote control function may become impossible.
For details on pairing, see "Pairing with a Transmitter"
on page 16.
17
Transmitter
(GP/CH)
(BAND)
(RF POWER)
Advertisement
Table of Contents
