Charger Operation - HITEC RDX1 Mini Instruction Manual

Charger Operation

The following steps describe how to manually setup the RDX1 Mini:
16
[cont.]
3. BATT/PROGRAM Select: Press INC and DEC to
scroll through all programs and press START/ENTER
to enter the LiPo BATT Program.
4. Mode Select: Press INC and DEC to scroll through
all modes and press START/ENTER to enter LiPo
Balance Charge Mode.
5. Battery Setting: Press START/ENTER. The current
value will start to blink, Press INC and DEC to
change the value and press START/ENTER to confirm
your setting.
At the same time, the battery cell's number will start
to blink. Press INC and DEC to change the value and
press START/ENTER to confirm your setting.
6. Program Start: Press and hold START/ENTER for 3
seconds to start the program.
The charger is detecting the number of cells.
R shows the number of cells detected by the
charger and S is the number of cells set by the
user at the previous screen. If the numbers are not
identical, press STOP to go back to the previous
screen and recheck the number of cells in the
battery pack before proceeding.