Royal BETTY 3.5 Installation, User And Maintenance Manual page 23

2 SAFETY PRECUATIONS
2.1 INSTRUCTIONS FOR THE INSTALLER
Make sure that the place of installation of the
stove meets all local, national and European rules
and regulations.
Comply with the indications given in this manual.
for the type of installation opted for and all local,
national and European rules and regulations.
The electrical connection must not be done using
temporary or non-insulated leads.
Check that the earthing of the electrical system is
Always use the individual safety devices and the
other protection gear as established by law.
2.2 INSTRUCTIONS FOR THE USER
Prepare the place of installation of the stove in
accordance with the local, national and European rules
and regulations.
Since the stove is an appliance that heats, its outer
surfaces can get very hot.
For this reason we advise maximum caution when
it is working, in particular:
A) Do not touch or go near the glass door as you
could get burnt;
B) do not touch the smoke discharge;
C) do not empty the ashes;
D) do not do any type of cleaning;
E) make sure that children are kept away.
Comply with the indications given in this manual.
Comply with the instructions and warnings given
on the plates on the stove.
The plates are accident prevention devices
and as such must be easily and perfectly legible at
all times. Should they be damaged and rendered
illegible it is compulsory to change them, asking the
manufacturer for an original plate.
Only use fuel that complies with the indications
given in the chapter referring to fuel characteristics.
Keep strictly to the maintenance programme to
the stove and to the system.
Do not use the stove without first having
"Maintenance" chapter in this manual.
Do not use the stove if there is a malfunction, a
suspected breakage or noises.
Do not throw water on the stove when it is lit or
Do not lean against the open door during the
cleaning operations.
Do not use the stove as a support or anchor of
any type.
cod. 00 477 3191 - 03/2016 - Royal - PN - Italy
Do not clean the stove until the structure and
ashes are completely cold.
All work must be carried out in maximum safety
and calmly.
In the event of a chimney fire, attempt to
Immediately call for emergency assistance.
against freezing wherever this may occur.
Do not use the stove as an incinerator for waste.
Use only recommended fuel.
If the stove malfunctions due to improper draught
tonnes of wood burnt, or at least once a year, unless
otherwise required by regulations.
especially severe weather conditions (typically
heated.
2.3 PRECAUTIONS FOR THE
MAINTENANCE ENGINEER
Comply with the indications given in this manual.
Always use individual safety devices and other
protection means.
Before undertaking any maintenance, if the
stove has been used, it must be completely cold.
Even if only one of the safety devices is not working,
the stove is to be considered "not working".
Disconnect from the electrical power supply
before working on electrical or electronic parts or
connectors.
.
23/68