Panasonic KX-TG1105RUS Service Manual page 34

Telephone equipment

Hide thumbs

Table Of Contents

Table of Contents

KX-TG1105RUS / KX-TG1105RUT / KX-TG1106RUS / KX-TG1106RUT / KX-TGA110RUS / KX-TGA110RUT

Items

(F)* Battery Monitor Check &

Adjustment (Important)

(G)

Battery Low

Confirmation (Important)

(H)* BBIC Clock Adjustment

(Important)

(I)*

Transmitted Power

Confirmation

(J)* Modulation Check and

Adjustment

(K)*

Frequency Offset

Confirmation

(L)*

Sensitivity Receiver

Confirmation

(M)*

Timing Confirmation

(N)*

RSSI Level

Confirmation

Adjustment

Point

1. Apply 2.3V ± 0.005V between TP3(+) and TP4(-) with DC power.

2. Execute the command "deactmac" to stabilize the value.

3. Then, execute the command "readbatt". The returned value is XX.

4. Confirm that XX is between 98 and A8.

98 < XX < A8 (Hex)

(If XX is out of range, change BBIC)

1. Apply 2.40V between TP3(+) and TP4(-).

2. Confirm that there is no Speaker sound (Battery low alarm).

3. Apply 2.20V between TP3(+) and TP4(-).

4. Confirm that there is Speaker sound (Battery low alarm).

TP19

1. Apply 2.6V between TP 3(+) and TP 4(-) with DC power.

2. Execute the command "deactmac".

3. Execute the command "conttx".

4. Input Command "rdeeprom 00 01 01", then you can confirm the current value.

5. Adjust the frequency of TP19 executing the command "setfreq 00 xx (where xx

is the value)" so that the reading of the frequency counter is 10.368000MHz

± 10Hz.

TP15

Remove the Antenna before starting steps from 1 to 5.

1. Configure the DECT tester (CMD60) as follows;

• • • • Test mode: PP

• • • • RFPI: 0102030405

• • • • Traffic Channel: 5

• • • • Traffic Slot: 4

• • • • Mode: Loopback

2. Execute the command "testmode".

3. Execute the command "regcmd60".

4. Initiate connection from DECT tester.

5. Confirm that the NTP value at A201 (TP15) is 20dBm ~ 25dBm.

TP15