Markings on the device
The nameplate (80) is affixed to the yoke of
the valve (see Fig. 2-2).
Fig. 2-2: Nameplate position
2.2 Actuator nameplate
See associated actuator documentation.
2.3 Material numbers
The seat and plug of the valves have an item
number written on them. Specifying this item
number, you can contact us to find out which
material is used. Additionally, a seat code is
used to identify the trim material. This seat
code is specified on the nameplate.
2-2
80
2.4 Label when an adjustable
packing is installed
An instructional label is affixed to the valve
when an adjustable packing is installed (see
Fig. 2-3).
Adjustable packing
Stem packing is NOT tightened down.
Adjust carefully as required during start-up!
xxxx-xxxx
Fig. 2-3: Label when an adjustable packing is
installed
ATTENTION !
EB 8052 EN