Setting Rf Link - Worcester DIGISTAT Instruction Manual

DIGISTAT ROOM THERMOSTAT
INSTALLATION
Care should be taken to mount the thermostat in a
position which is not subject to direct sunlight or
draughts. Preferably it should be mounted on an
inside wall about 1.5m (5ft.) above the floor in a
position where it can respond to room temperature
but away from the direct influence of radiators or
other appliances giving off heat.
NOTE: Refer to the Technical Data page for
guidance on Digistat transmitter range.
For latest prices and delivery to your door visit MyTub Ltd - www.mytub.co.uk - info@mytub.co.uk 0844 556 1818
DT20RF PROGRAMMER
INSTRUCTION MANUAL
8 716 114 478a (08.07)
DT20RF RECEIVER
SETTING THE RF LINK
Receiver set up:
After initial start up, the colon, CH and antenna
symbols should be flashing on the display.
1. Press the set? button 4 times.
2. Press the OK button once.
3. Press the set? button 4 times; Lrn and OFF
should be displayed.
4. Press the + button so the display shows ON and
a flashing antenna symbol. The learn mode is now
ready to receive a signal from the transmitter dur-
ing the next two minutes.
Transmitter set up:
1. Take the Digistat Room Thermostat and stand
approximately two metres away from the boiler.
2. Remove the battery cover and fit the batteries.
The symbols on the receiver will stop flashing and
the display will return to the normal time display.
This confirms that the radio signal is being sent
and received.
The Digistat Room Thermostat is now linked to
the receiver on the boiler.
OPER AT ING & INSTA L L AT ION
INST RUCT IONS
17