Key Features; Getting Started - Remington Ultimate Series Quick Start Manual

KEY FEATURES

1. On/off switch
2. Intercept trimmer
3. Shaving foils
4. Hair pocket
5. 3 stage charge indicator (F7)
6. LED display (F8)
7. Charging pins (on back)

GETTING STARTED

Charge the shaver:
1. Ensure the product is switched off.
2. Connect the charging stand to the adaptor and then to the mains.
3. Place the charge stand on a flat surface.
4. Place the shaver in the charge stand with the charge pins contacting.
• Charge for at least 24 hours when using for the first time.
• F7: At low charge the LED indicator will flash rapidly. When charging the LED will flash
slowly.
• When fully charged the LED will light for 1 minute and then turn off.
• F8: When charge is low 'Lo' will flash rapidly on the screen. When charging, the LED's
flash in a clockwise rotation.
• When fully charged the minutes will flash 60 for 1 minute and then turn off.
• To preserve the life of your batteries, let them run out every 6 months then recharge
for 24 hours.
• The appliance adapts automatically to a mains voltage between 100V and 240V.
Quick charge
• Quick charge feature: Your shaver is fitted with a 5 minute quick charge feature that
will provide enough charge for 1 shave (3 minutes).
INSTRUCTIONS FOR USE
It is recommended that you use your new shaver daily for up to four weeks to allow time
for your beard and skin to become accustomed to the new shaving system.
Shaving
1. Switch the shaver on by pressing the on/off switch.
2. Stretch the skin with your free hand so the hairs stand upright.
3. Hold the shaving head so that the foils touch your face.
4. Use short, linear strokes.
4
8. Pop-up trimmer (on back)
9. Foil assembly release buttons
10. Charging stand
11. Adaptor (not shown)
12. Head guard (not shown)
13. Storage pouch (not shown)