Parent Unit Power Supply - Motorola MBP668CONNECT User Manual

2.3

Parent Unit Power Supply

IMPORTANT
Installing the rechargeable battery pack and charging it fully before use is
recommended. This will allow the unit to operate on battery in the event of a
power failure.
1. Connect the small plug of the power adapter to the parent unit and the
other end to the electrical outlet. Only use the enclosed power adapter
(5V DC / 1000mA) with the slightly smaller DC plug.
2. Press and hold the
the parent unit.
3. Once the baby and parent units are switched on, the display on the parent
unit will show the video captured by the baby unit.
4. If there is no connection or you are out of range, the video display will go
off and the words
will beep every 5 seconds. Move the parent unit closer to the baby unit until
the link is re-established.
5. Press and hold the
finishes scrolling, to turn OFF the parent unit.
NOTE
The battery icon
a beep every 16 seconds. The battery needs to be recharged. The battery pack
takes about 16 hours to charge fully.
12
P
POWER ON/OFF button for 1 second to turn ON
No Signal
will be shown on the LCD display, and the unit
P
POWER ON/OFF button, until the progress bar
turns RED to indicate that the battery is low, and it gives
Getting Started