Table of Contents
Advertisement
3 Select a voice command then choose an entry.
4 Select
Replace Voice
To listen to a recorded voice command, select
.
Play Voice
5 Lift the phone to your ear, wait for the tone and say
the command.
You can also edit the voice command for a contact name
in
in the
Edit Contact
Phonebook
Tips
• Try to record in an area where there is little or no
background noise or other people speaking.
• Try to record your voice with the same equipment that
you normally use with your phone. For example, if you
normally have your phone connected to a portable
handsfree device when using voice commands, record
your voice commands when your phone is attached to
a portable handsfree device.
• If you plan to use voice functions handheld mode, hold
the phone up to the ear in the position that would
normally be used on a call.
• Begin speaking after the tone ends.
• Keep in mind that longer tags provide a higher
recognition rate.
62
Using Voice Commands
and press Select.
menu.
• Shorter tags may cause a lower recognition rate. For
example, the name "Tom" can easily be confused with
"Tim".
• Record your voice using the same tone and inflection
as you would when normally speaking. Try not to
overpronounce or speak too slowly when recording.
• When using Portable handsfree devices, you can easily
activate voice dialing by pressing the button near the
microphone until you hear a prompt.
Troubleshooting
If your phone cannot detect speech, one of the following
might have happened:
• You spoke too softly – try speaking more loudly.
• You held the phone too far away – hold it as you do
during a call.
• The voice command was too short – it should be
around one second long.
• You spoke too late or too soon – speak immediately
after the tone.
• You may want to re-record the voice command.
Advertisement
Table of Contents
