Chapter 6. Delivery And Installation Requirements; Acclimation - IBM DS8882F Introduction And Planning Manual

Chapter 6. Delivery and installation requirements

You must ensure that you properly plan for the delivery and installation of your
storage system.
This information provides the following planning information for the delivery and
installation of your storage system:
v Planning for delivery of your storage system
v Planning the physical installation site
v Planning for power requirements
v Planning for network and communication requirements
For more information about the equipment and documents that IBM includes with
storage system shipments, see Appendix C, "IBM equipment and documents," on
page 125.

Acclimation

Server and storage equipment must be gradually acclimated to the surrounding
environment to prevent condensation.
When server and storage equipment is shipped in a climate where the outside
temperature is below the dew point of the destination (indoor location), there is a
possibility that water condensation can form on the cooler inside and outside
surfaces of the equipment when the equipment is brought indoors.
Sufficient time must be allowed for the shipped equipment to gradually reach
thermal equilibrium with the indoor environment before you remove the shipping
bag and energize the equipment. Follow these guidelines to properly acclimate
your equipment:
v Leave the system in the shipping bag. If the installation or staging environment
v Allow the packaged product to acclimate for 24 hours.
v Acclimate the product away from perforated tiles or other direct sources of
1
Note: Condensation is a normal occurrence, especially when you ship equipment
in cold-weather climates. All IBM
condensation that is produced under these circumstances. When sufficient time is
provided to allow the hardware to gradually acclimate to the indoor environment,
there should be no issues with long-term reliability of the product.
© Copyright IBM Corp. 2018
allows it, leave the product in the full package to minimize condensation on or
within the equipment.
of condensation (either external or internal to the product) after 24 hours,
acclimate the system without the shipping bag for an additional 12 - 24 hours or
until no visible condensation remains.
forced air convection to minimize excessive condensation on or within the
equipment.
Unless otherwise stated by product-specific installation instructions.
®
products are tested and verified to withstand
1
If there are visible signs
89