CAUTION IN SERVICING
Initializing INTEGRATED AMPLIFIER
INTEGRATED AMPLIFIER initialization should be performed when the μcom and peripheral parts of μcom were replaced.
1.
Turn off the power pressing "POWER" button.
2.
Press "POWER" button while simultaneously while pressing "SOURCE DIRECT" buttons.
3.
Check the set entered the service mode.(See
POWER
Service Jigs f
The following jigs are used when updating the firmware.
(RS232C → connector conversion board in this product + 7P cable kit)
Request service from your dealer if necessary.
8U-210100S
606050028012P
(See
"FIRMWARE UPDATE PROCEDURE" 15
"SERVICE MODE"
SOURCE DIRECT
:
WRITING KIT
:
7P FFC (Straight)
page.)
15page.)
:
1 Set
:
1 Set
10