Setup
NOTICE
This equipment is compatible with most water-based
materials. See the wetted parts in the Technical Data
section and your fluid and solvent manufacturer's
compatibility information.
Prepare the operator
All persons who operate the system should be trained in
the safe, efficient operation of all system components as
well as the proper handling of the chemical coating. At a
minimum, all operators should thoroughly read the
safety, installation and operation sections of this manual
and the component manuals.
Prepare the site
To prevent hazardous concentrations of toxic and/or
flammable vapors, spray only in a properly ventilated
spray booth. Never operate the spray gun unless
ventilation fans are operating. Check and follow all
of the national, state and local codes regarding air
exhaust velocity requirements.
1. Use a minimum 5 HP (3.7 kW) air compressor for
efficient operation.
2. Clear obstacles and debris that could cause an
unsafe operating environment.
3. Bring an air line from your compressed air supply to
the pressure pot location. Be sure the air is dry and
filtered. Install a bleed-type master air valve
upstream from the pressure pot. When it is closed
and the pressure pot air regulator (33) is opened,
the bleed-type master air valve relieves all air pres-
sure to the equipment components.
4. Ventilate the spray booth.
Setup
5