To Replace Needle Threader Plate - Janome MC6600 Service Manual

TO REPLACE NEEDLE THREADER PLATE

(FIG.I)
THREADER PLATE (C)
(X) VIEW
SETSCREWS (E)
(FIG. III)
SETTING
PLATE (G)
NEEDLE BAR
PIN (B)
THREADER PLATE
UNIT (A)
(FIG. II)
(X)
SETSCREW (D)
HEXAGONAL
SOCKET SCREW (F)
[TO REMOVE]:
1 REMOVE THE FOOT HOLDER.
2 PULL OUT THE THREADER PLATE UNIT (A).
[TO ATTACH]:
3 PUSH THE THREADER PLATE UNIT (A) UP TO
SNAP IT WITH THE PIN (B) AS SHOWN IN FIG. I.
4 ATTACH THE FOOT HOLDER
TO ADJUST THE POSITION OF THE
THREADER PLATE (C)
IF THE THREADER HOOK THRUSTS OR HITS
AGAINST EITHER LEFT OR RIGHT EDGE OF THE
NEEDLE EYE:
LOOSEN SCREW (D) AND ADJUST THE POSITION
OF THE THREADER PLATE (C).
IF THE THREADER HOOK THRUSTS AGAINST
EITHER TOP OR BOTTOM EDGE OF THE NEEDLE
EYE, OR MISSES THE NEEDLE EYE:
REMOVE THE FACE COVER AND LOOSEN THE
HEXAGONAL SOCKE SCREW (F). MOVE THE
SETTING PLATE (G) UP OR DOWN TO ADJUST THE
HOOK POSITION. THEN TIGHTEN THE SETSCREW
(F).
24