Advertisement
To set the temperature you require, turn the thermostat knob clockwise
until the desired temperature is reached. Alternatively to heat a cold room
quickly, turn the thermostat knob up fully.
When the room has reached the desired temperature, turn the thermostat
knob anti-clockwise until the thermostat just clicks off.
The heater will now automatically operate at this temperature.
Timer Operation (see 'C' in Fig. 8)
(OFX750TI/1000TI/1500TI Models)
Set the I -
-
slide switch on the timer (Fig. 9) to :
Position
- Heating Off
Position I - Manual operation
This setting allows power to the heater uninterrupted by the timer settings.
Note: The thermostat should be set to the required heat setting.
Position
- Auto operation
DO NOT disconnect this heater from the mains supply unless it is being
taken out of use (e.g. in summer or for storage), otherwise the timer
clock will stop.
Setting the time of day
To set the time of day, rotate the timer dial clockwise (indicated by the
arrow) until the correct time of day is opposite the reference mark
(see Fig. 9). The 24-hour clock is used ; e.g. time shown for 4 pm is '16'
(16:00hrs).
Setting the Auto ON and OFF times
To set the timer:
1. Using your finger tip or the tip of a pencil, push in as many segments
as necessary around the dial, according to the times you don't require
heat – see Fig. 10. Each segment pushed in switches the heater
OFF for that part of the hour. All other segments will be ON. For
example, Fig. 11 shows the timer set to switch the heater ON between
7.00am and 9.00am and between 4.00pm and 9.30pm.
2. You can select as many ON periods as you like, within the 24-hour
day. The settings will repeat every day until changed.
3. To change ON and OFF times, simply push in any ON segments you
wish to cancel and pull out new ON segments as required.
Switching to Auto
Set the thermostat for the heat output required.
Check that the clock shows the correct time of day. Set the I -
slide switch to
(see Fig. 12) - the heater will switch ON and OFF
according to the timer settings (see Fig. 11).
IMPORTANT NOTES
Remember to observe all safety warnings when operating the heater on
auto setting unattended or attended .
If the mains supply to the heater is interrupted, the timer clock will stop
until power is restored ; reset the time of day to ensure correct ON and
OFF times.
Dimplex UK Limited
Millbrook House
Grange Drive
Hedge End
Southampton
Hampshire. SO30 2DF
[c] Dimplex UK Limited
All rights reserved. Material contained in this publication may not be reproduced in whole or in part, without prior permission in writing of Dimplex UK Limited.
Safety – Overheat Protection - all models
The heater is fitted with a thermal safety cut-out which will switch off
the heater should it overheat for any reason. If the cut-out
operates it is the result of abnormal overheating, and the Customer
Services Helpline should be contacted for further advice.
Cleaning
WARNING – ALWAYS DISCONNECT FROM THE POWER SUPPLY AND
ALLOW THE RADIATOR TO COOL BEFORE CLEANING.
Do not use detergents, abrasive cleaning powder or polish of any kind
on the body of the radiator, as these can damage the finish.
Wipe the radiator with a dry cloth to remove dust and a damp cloth (not
wet) to clean off stains.
Be careful not to allow moisture to enter the control box.
Recycling
For electrical products sold within the European Community.
At the end of the electrical products useful life it should not be disposed
of with household waste. Please recycle where facilities exist. Check
with your Local Authority or retailer for recycling advice in your country.
After Sales Service
Your product is guaranteed for three years from the date of purchase.
Within this period, we undertake to repair or exchange this
product free of charge (subject to availability) provided it has
been installed and operated in accordance with these
instructions.
Your rights under this guarantee are additional to your statutory
rights, which in turn are not affected by this guarantee.
Should you require after sales service you should contact our customer
services help desk on 0845 600 5111. It would assist us if you can quote
the model number, series, date of purchase, and nature of the fault at the
time of your call. The customer services help desk will also be able to
advise you should you need to purchase any spares.
Please do not return a faulty product to us in the first instance as this
may result in loss or damage and delay in providing you with a satisfactory
service.
This heater is filled with a precise quantity of special oil. Repairs requiring
opening of the oil container are only to be made by the manufacturer or
its service agent. For further advice if an oil leak is suspected please
-
contact our Customer Services Helpline. Regulations concerning the
disposal of oil when scrapping the appliance must be followed.
Please retain your receipt as proof of purchase.
UK customer help line 8.00am–5.00pm Mon-Fri and 8:30am-1.00pm Sat (October-March)
Customer Services:
Tel.
Fax.
e-mail customer.services@glendimplex.com
Republic of Ireland
Tel.
0845 600 5111
01489 773053
01 8424833
Advertisement
