Additional Information; General Setup Information - Sony SLV-N51 Operating Instructions Manual

Additional Information

General setup information

Setting the RF unit
When connecting the VCR to the TV using
only the antenna cable, you must set the CH
switch on the rear of the VCR so that the TV
can receive the correct signal from the VCR.
CH
3 4
?/1 POWER
CHANNEL +/–
1
Set the CH switch on the rear of the VCR to 3 or 4, whichever channel is not used
in your area. If both are used, set the switch to either channel.
2
Press ?/1 POWER to turn on the VCR.
3
Press TV/VIDEO to turn on the VCR indicator in the VCR's display window.
4
Press CHANNEL +/– to display a channel number in the display window.
Select an active channel number in your area.
5
Turn on your TV and set it to the channel you selected in step 1 (channel 3 or 4).
The channel you selected in step 4 appears on the TV screen. If the channels
change when you press CHANNEL +/–, you have made the correct setting.
Whenever you use the VCR, set the TV to the channel selected in step 1.
50
General setup information
TV
TV/VIDEO
1 2 3
4 5 6
7 8 9
0