Setup Menu; Item-F Series - Sony BKDW-515 Installation And Maintenance Manual

This section describes the menu ITEM-F series used during adjustment. For the operation and ITEM-H00
to ITEM-900 series, refer to the Operation Manual.
3-1.

ITEM-F Series

Display the ITEM-F series according to the procedure below.
1. Press the SETUP key to enter the setup menu.
2. Press the F6 (VTR SETUP) key to enter the VTR SETUP menu.
3. Press the cursor key while pressing the PLAY button.
Item selection
Press the cursor key while pressing the PLAY button and adjust the cursor on the scroll screen to the
arbitrary item.
Data change
Press the F7 (CHANGE DATA) key to open the set change screen and select the data.
Data setting
Press the F10 (SAVE/EXIT) key.
n
These ITEM-F series are exclusively used for adjustment. After adjustment is completed, return data to
the factory setting.
ITEM DATA
No. ITEM No.
F01 AUDIO NR IN 0
SP MODE 1
F02 EMERGENCY 0
TAPE 1
PROTECTION
F07 CONFI SELECT 0
IN PB MODE 1
BKDW-515
Section 3

Setup Menu

Description
DATA
on This item is prepared exclusively for audio adjustment. After adjustment is
switch select completed, return to the factory setting '0 (on)'.
Select the type of control to turn Dolby noise reduction ON in the metal tape
playback.
0: Dolby NR is normally ON when mental tape is used.
1: Dolby NR is switched ON and OFF depending upon the DOLBY NR switch
setting on the sub control panel.
(NOTE)
When oxide tape is used, it is controlled depending upon the DOLBY NR switch
setting on the sub control panel, regardless of the setting of this menu item.
enable This item is prepared exclusively for servo and mechanical adjustments. After
disable adjustment is completed, return to the factory setting '0 (enable)'.
Select whether the emergency tape protection operation is enabled or not when
VTR detects error in tape transport mechanism.
0: Tape protection operation is enabled.
1: Tape protection operation is disabled.
disable Selects the playback by the confidence head enable or disable in the normal PB
enable mode of the digital mode.
0: Disables the playback by the confidence head in the normal PB mode.
1: Enables the playback by the confidence head when the CONFI mode is
entered (the CONFI lamp on the lower control panel lights) in the normal PB
mode.
3-1