Sony RM-AX4000 Operating Instructions Manual page 18

Installing the "AX Remote Editor"
(continued)
For Windows XP users
1
Close all software running on
Windows.
2
Insert the supplied CD-ROM into
the CD-ROM drive of the PC.
After a moment, "InstallShield
Wizard" of "AX Remote Editor"
appears.
3
Click [Cancel] to close
"InstallShield Wizard" of "AX
Remote Editor."
4
Connect the PC and the Remote
Commander using the supplied
USB mini cable (page 19).
The "Found New Hardware" message
appears in the Notification Area in the
lower right-hand of the display. After
a moment, "Found New Hardware
Wizard" appears.
5
Select "Install the software
automatically [Recommended]",
then click [Next].
Installing of the USB driver starts. The
"Completing the Found New
Hardware Wizard" display appears
when the installation is complete.
6
Click [Finish].
Installing of the USB driver finishes.
18
For Windows 2000 users
1
Close all software running on
Windows.
2
Insert the supplied CD-ROM into
the CD-ROM drive of the PC.
After a moment, "InstallShield
Wizard" of "AX Remote Editor"
appears.
3
Click [Cancel] to close
"InstallShield Wizard" of "AX
Remote Editor."
4
Connect the PC and the Remote
Commander using the supplied
USB mini cable (page 19).
The "Found New Hardware" message
appears. After a moment, "Found
New Hardware Wizard" appears.
5
Click [Next].
The "Install Hardware Device
Drivers" display appears.
6
Select "Search for a suitable
driver for my device
[recommended]", then click
[Next].
The "Locate Driver Files" display
appears.
7
Mark only the check box of "CD-
ROM drives", then click [Next].
The "Driver Files Search Results"
display appears, and the found driver
is displayed.