Sony RM-AX5000 Quick Start Manual

Integrated Remote Commander
RM-AX5000
Operating Instructions
Quick Start Guide
Owner's Record
The model number is located on the rear of the unit and the serial number
is located in the battery compartment.
Record the serial number in the space provided below. Refer to them
whenever you call upon your Sony dealer regarding this product.
Model number : RM-AX5000
Serial number :
http://esupport.sony.com/US/RMAX5000/
© 2008 Sony Corporation Printed in Malaysia
Contents
• Remote Commander • Rear Cover • Battery Charging
"RM-AX5000" Stand "BCA-RMAX5K"
• Ni-MH Rechargeable • AC Power Adaptor • USB Cable
Battery Pack
• CD-ROM
• Quick Start Guide
• Warranty Card
Installing the battery
Insert the connector with the Ni-MH
Rechargeable Battery Pack into the
Remote Commander.
Be sure to match the direction of the
connector.
Attach and slide the Rear Cover.
Be sure to match the direction of the Rear
Cover. Align the bottom of the Rear Cover
to the Attaching line.
Attaching line
Charging the battery
Connect the AC Power Adaptor
DC IN 6 V jack
plug directly to the DC IN 6 V jack
CHARGE indicator
on the Remote Commander. Then
connect the AC Power Adaptor to a
wall outlet.
Charging starts when the CHARGE
indicator in the top of the display is lit.
AC Power Adaptor
plug
Charging is completed when the CHARGE indicator turns off. Disconnect
the AC Power adaptor. Then slide to close the Rear Cover.
1
Install "RM-AX5000 Custom
Setup Tool" to your Windows
PC.
Complete the installation by following the on-screen instructions.
2
Connect the Remote
Commander to your PC.
to your PC
USB Cable
AC Adaptor
(to a wall outlet)
3
Start "RM-AX5000 Custom
Setup Tool and register a
Component."
"RM-AX5000 Custom Setup Tool"
Start
Set up your Component by following the simple on-screen instructions.
Below are the main steps you will go through to set up your Remote
Commander.
Select "First Setup Wizard. "
Specify the Model number in the "Configure" window.
Sync the Remote Commander with this Wizard setting.
4
Disconnect the Remote
Commander.
5
Let's try using the Remote
Commander!
(e.g.) To operate a TV which has just been set up.
 Press the "POWER" button
to turn the TV on.
 Press the Label button "TV. "

Press the "OTHER" button.
 Press the Label buttons
or Hardware buttons for
desired operations.