Sony RM-AV2500T Operating Instructions Manual page 39

To transfer the data of a
Component Select button
The data of a Component Select button
on this Commander (the settings and
learned signals programmed on the keys
and buttons) can be transferred to a
Component Select button on another
Sony RM-AV2500T.
1~3
Perform Steps 1 to 3 on page
38.
4
Press the 2 key.
5
Press the Component Select
button whose data you want to
send.
6
Confirm that the receiving remote
commander is ready to accept
data.
(To set the receiving commander,
follow the procedure on page 40.)
7
Press the "ENTER" key.
When the data has been transferred,
"TV" and "R" go off. If the data have
been successfully transferred, the
backlight of the display turns off.
Note
If "NG" appears while sending the data, go
back to Step 6 and continue the operation
or press COMMANDER OFF to stop the
operation.
Notes
• The data of the "learned" signal and the
System Control function programmed for a
Component Select button cannot be
transferred.
You can use the learning function (page 32) to
programme the "learned" signal and the
System Control functions programmed for a
Component Select button on another remote
commander.
• Be sure that the receiving remote commander
is ready to receive data.
Continued
GB
39