Sony RM-AV2000T Operating Instructions Manual page 12

2
Press the desired key in the touch
key display.
When the remote control signal is
sent, is displayed on the display.
You may also use the Á +/– buttons,
the ¤ button and the PROGRAM +/–
buttons if necessary.
3
When you are done using the
Commander, press
COMMANDER OFF to power off
the Commander.
COMMANDER
OFF
Note
The remote control signals may be different for
some components or functions. In this case,
program the remote control signals with the
learning function (see page 12). Note, however,
that components and functions that do not
support the remote control of infrared signals
will not work with this Commander.
To control the volume
Press the Á +/– buttons to control the
volume, and the ¤ button to mute.
When you select a visual component, the
TV's volume will be controlled, and
when you select an audio component, the
amplifier's volume will be controlled.
You can change this setting also
(page 17).
When you operate a Sony VCR
Select the VCR1, 2, or 3 button to match
the VTR1, 2 or 3 switch on your VCR. If
your VCR does not have a VTR1, 2, or 3
switch, select VCR1, 2, or 3 according to
the type of VCR as follows.
Betamax
8mm
VHS
When you operate a VCR REC
(record) key
In order to avoid recording by mistake,
the REC key does not work by itself. To
record, you must press the ( key while
pressing the REC key.
When you operate a double
cassette deck
You need to select deck A or B before
operating. To select the deck, press
DECK B/A to switch the display between
"DECK A" and "DECK B".
If the remote control for your cassette
deck has only one set of operating
buttons and has an A/B button for
selecting a deck, press the D.SKIP key in
the touch-key display instead.
VCR1
VCR2
VCR3
Continued
EN
11