Monitoring The Access Point Leds - Cisco Aironet 1530 Series Hardware Installation Manual

Monitoring the Access Point LEDs

Monitoring the Access Point LEDs
If your access point is not working properly, look at the LEDs on the bottom of the unit. You can use
them to quickly assess the status of the unit.
Figure 3-1
Note It is expected that there will be small variations in LED color intensity and hue from unit to unit. This is
within the normal range of the LED manufacturer specifications and is not a defect.
The access point LED signals are listed in
LED Message
Type
Boot loader
status sequence
Boot loader
warnings
Cisco Aironet 1530 Series Outdoor Access Point Hardware Installation Guide
3-4
Access Point LEDs –Shown on the Bottom of AP 1532E
Table
Table 3-1 Access Point LED Signals
Color
Blinking Green
Blinking Amber
Solid Red
Blinking Green
Figure 3-1 shows the location of the access point LEDs.
3-1.
Meaning
Boot loader status sequence:
DRAM memory test in progress
•
DRAM memory test OK
•
Board initialization in progress
•
Initializing FLASH file system
•
FLASH memory test OK
•
Initializing Ethernet
•
Ethernet OK
•
Starting Cisco IOS
•
Initialization successful
•
Configuration recovery is in progress (the MODE button
has been pushed for 2-3 seconds)
There is an Ethernet failure or an image recovery (the
MODE button has been pushed for 20-30 seconds)
An image recovery is in progress (the MODE button has
been released)
Chapter 3 Troubleshooting
LED
Indicator
OL-30864-01