Sony MKS-2010 User Manual page 158

[SHIFT] Off
[SHIFT] On
a) For a 1.5 M/E wide panel, button numbers: 1 to 20
b) For a 1.5 M/E wide panel, button numbers: 21 to 40
c) The signal assignment to these buttons cannot be changed.
d) The numbers in parentheses are the button numbers when shift mode is on (set to something other than Off).
To use the rightmost buttons in cross-point
button rows as [SHIFT] buttons (shift mode
selection)
By a XPT Assign menu setting, you can use the rightmost
buttons on cross-point button rows (the 12th buttons on
1M/E or 1.5M/E panels, or the 20th buttons on 1.5M/E
wide panels) as [SHIFT] buttons, which switch between
cross-point button numbers.
In the XPT Assign menu, press [Shift Mode] to display a
popup window, and select a setting other than Off.
Hold: Shift-side cross-point buttons are enabled as long as
the rightmost button is held down.
Lock: Shift-side cross-point buttons are enabled as long as
the rightmost button is on.
Off: Do not use the rightmost buttons as [SHIFT] buttons.
Note
The dedicated [SHIFT] button above the cross-point
button rows is disabled when you select a setting other than
Off.
Signals assigned to cross-point buttons
You can assign two signals, the video signal and key
signal, as a pair to each cross-point button number. With
this unit you can register a maximum of 40 pairs of video
and key signals. For each pair the assigned number is
referred to as a pair number. The signal assignment to
158
Basic Settings
Cross-point button numbers in the AUX bus control block
AUX DELEGATION
AUX1 AUX2 AUX3 AUX4
KEY1 KEY2 DSK1 DSK2
AUX
BLACK
a)
: 1 2 3
b)
: 13 14 15 16
d)
(12) (13) (14) (15)
EDIT
UTIL
PVW
FRAME
CCR1 CCR2
MEM
4 5 6 7 8
17 18 19 20
(16) (17) (18) (19)
cross-point buttons is done by assigning pair numbers to
cross-point button numbers.
For the operation of combining a video signal and key
signal, see "Creating a pair from a video signal and key
signal" (page 159).
Assigning signals to cross-point buttons
To carry out the assignment of a video signal and key
signal pair to a cross-point button, use the Xpt Assign
menu.
1
From the top menu, select Setup/Diag >Operation
>Xpt Assign.
The Xpt Assign menu appears.
XPT/KY HOLD button
Dedicated SHIFT button
SRC XP/KY
KEY SHIFT
BUS HOLD
M/E PGM
COLOR
BKGD
9 10 11 12
(SHIFT)
21 22 23 24
(20) (21) (22) (SHIFT)
c)