Enhancing Your System; Troubleshooting Chart - Sharp XL-DH259N Operation Manual

Enhancing your system

The connection cord is not included. Purchase a
commercially available cord as shown below.
Portable audio
player, etc.
Audio cable
(not supplied)
Listening to the playback sounds of
portable audio player, etc.
1
Use a connection cord to connect the portable audio
player etc. to the AUDIO IN jack. When using video
equipment, connect the audio output to this unit and the
video output to a television.
2
Press the ON/STAND-BY button to turn the power on.
3
Press the AUDIO IN button on the remote control or
FUNCTION button repeatedly on main unit to select
AUDIO IN function.
4
Play the connected equipment. If volume level of the
connected device is too high, sound distortion may
occur. Should this happen, lower the volume of the
connected device. If volume level is too low, increase
the volume of the connected device.
Note:
To prevent noise interference, place the unit away from the
television.
Headphones
● Do not turn the volume on to full at switch on and listen
to music at moderate levels. Excessive sound pressure
from earphones and headphones can cause hearing
loss.
● Before plugging in or unplugging the headphones,
reduce the volume.
● Be sure your headphones have a 1/8" (3.5 mm)
diameter plug and impedance between 16 and 50
ohms. The recommended impedance is 32 ohms.
● Plugging in the headphones disconnects the speakers
automatically. Adjust the volume using the VOLUME
control.

Troubleshooting chart

Many potential problems can be resolved by the owner
without calling a service technician.
If something is wrong with this product, check the following
before calling your authorized SHARP dealer or service
center.
● The clock is not set
● When a button is
● No sound is heard.
M I C R O C O M P O N E N T S Y S T E M
XL-DH259
● Playback does not
● Playback stops in
● Playback sounds are
● The remote control
● The radio makes
E-13
General
Symptom
● Did a power failure occur?
to the correct time.
● Set the unit to the power
pressed, the unit
does not respond.
● If the unit still malfunctions,
● Is the volume level set to
● Are the headphones
● Are the speaker wires
CD player
Symptom
● Is the disc loaded upside
start.
● Does the disc satisfy the
the middle or is not
● Is the disc distorted or
performed properly.
● Is the unit located near
skipped, or stopped
● Is the disc very dirty?
in the middle of a
● Has condensation formed
track.
Remote control
Symptom
● Is the AC power cord of the
does not operate.
● Is the battery polarity
● Are the batteries dead?
● Is the distance or angle
● Does the remote control
Tuner
Symptom
● Is the unit placed near the
unusual noises
● Is the FM antenna or AM
continuously.
Possible cause
Reset the clock. (Refer
page 10)
stand-by mode and then
turn it back on.
reset it. (Refer page 14)
"0"?
connected?
disconnected?
Possible cause
down?
standards?
scratched?
excessive vibrations?
inside the unit?
Possible cause
unit plugged in?
correct?
incorrect?
sensor receive strong
light?
Possible cause
TV or computer?
loop antenna placed
properly? Move the
antenna away from the AC
power cord if it is located
nearby.