Performing Several Commands In Sequence Automatically (Macro Play) - Sony STR-DE897 Operating Instructions Manual

To activate the input after
programming
Press the programmed button to activate the
input you want.
To cancel learning
Press RM SET UP during any step. The remote
automatically exits the learning mode.
To clear the learned codes
Start over from step 1. After step
TV ?/1 for more than 2 seconds. The indicator
lights up twice slowly and the learned code is
cleared. If TV ?/1 is pressed less than 2
seconds, the learning procedure returns to the
beginning of step 5.
When a learned code is cleared, if the button was
previously programmed for another input
selector, the programmed code for that button
can be used.
To clear the memory of the
remote
To clear all programmed and learned signals, do
the following to reset the remote to factory
settings.
Press ?/1, AV ?/1 and MASTER VOL – at
the same time.
The indicator flashes 3 times, then goes off.
To use a command that has been
learned
When selecting a learned input, press the learned
button for that input.
GB
52
The Macro Play function lets you link several IR
codes in a sequential order as a single command.
, press The remote provides 2 macro lists (M1 and M2).
3
You can specify up to 10 IR codes for each
macro list.
Setting the sequence of IR codes
1
2
3
4
5
Performing several
commands in sequence
automatically
(Macro Play)
Press M1 (or M2) while holding down
RM SET UP.
The indicator lights up.
Press the numeric buttons to select the
macro step number.
For example, to program step 1, press 1.
The indicator flashes slowly.
Point the remote control code receiver
section of the remote towards the
receiver/transmitter on the remote
control to be learned.
Press the appropriate button on the
remote control to be learned to send
the remote button code.
Lightly pressing the button once should be
sufficient.
If learning is completed successfully, the
indicator slowly flashes twice and the
remote automatically exits the learning
mode.
When learning is not completed
successfully, the indicator flashes 4 times in
quick succession and the procedure returns
to step 4.
Repeat steps 1 through 4 to program
up to 10 IR codes.