Adjusting The Equalizer; Advanced Settings - Sony STR-DB795 Operating Instructions Manual

Adjusting the equalizer

You can adjust the tonal quality (bass, treble
level) of each speaker using the EQ menu.
Bass
Level
(dB)
Frequency
(Hz)
1
Start playing a source encoded with
multi channel surround effects (DVD,
etc.).
2
Press MAIN MENU repeatedly to select
"EQ".
3
Rotate MENU to select the parameter.
For details, see "EQ menu parameters"
below.
4
While monitoring the sound, rotate –/+
to adjust the selected parameter.
5
Repeat steps 3 and 4 to adjust the other
items.
Note
You cannot adjust the equalizer when the system is
decoding PCM 96 kHz signals, or when DTS 96/24,
DTS-ES Matrix or DTS Neo:6 decoding is applied.
EQ menu parameters
x EQ
Initial setting: OFF
Select "ON" to activate the equalizer.
x BASS XXX.X dB
L R
(Front speaker bass level)
x TREB. XXX.X dB
L R
(Front speaker treble level)
Initial setting: 0 dB
You can adjust from –10 dB to +10 dB in 1 dB steps.
Treble
Frequency
(Hz)

Advanced settings

Using the CUSTOMIZE menu
to adjust the receiver
You can adjust various receiver settings using
the CUSTOMIZE menu.
1
Press MAIN MENU repeatedly to select
"CUSTOM".
2
Rotate MENU to select the parameter.
For details, see "CUSTOMIZE menu
parameters" below.
3
Rotate –/+ to adjust the selected
parameter.
4
Repeat steps 2 and 3 to adjust the other
items.
CUSTOMIZE menu parameters
The initial setting is underlined.
x MENU (Menu expanding)
• MENU EXP.
The advanced parameters for the SP SETUP and
LEVEL menus are displayed and can be adjusted.
For details on each setup item, see pages 17, 35 and
the following pages.
• MENU STD
The advanced parameters are not displayed.
x
96 XXXX
DTS 96/24
(DTS 96/24 decoding mode)
• 96 AUTO
When a DTS 96/24 signal is input, it is played back
at 96 kHz sampling frequencies.
• 96 OFF
Even when a DTS 96/24 signal is input, it is played
back at 48 kHz sampling frequencies.
Notes
• This parameter is valid only in the A.F.D. mode
(page 29). In other sound fields, this parameter is
always set to "96 OFF".
• DTS 96/24 decoding is only valid in the A.F.D. mode
(page 29). When the system is set to other sound
fields, standard 48 kHz decoding is used.
• Even when a DTS 96/24 signal is input, standard 48
kHz decoding is used if any speakers are set to
"SMALL" or if the sub woofer is set to "NO".
continued
37 GB