Troubleshooting; Problems And Remedies - Sony MHC-RV60 Operating Instructions Manual

Troubleshooting

Problems and remedies

Should you encounter a problem with your
system, do the following:
1
Make sure the power cord and speaker
cords are correctly and firmly connected.
2
Find your problem in the troubleshooting
checklist below and take the indicated
corrective action.
If the problem persists after doing all of the
above, consult your nearest Sony dealer.
When the ?/1 indicator flashes
Immediately unplug the power cord and check
the following items.
• Is the voltage selector set to the correct
voltage?
Check the voltage for your region, then make
sure the voltage selector is set correctly.
• Are the + and – speaker cords short-circuited?
• Are you using only the prescribed speakers?
• Is anything blocking the ventilation holes on
the rear of the system?
Check all the above items and fix any problems
found. After
reconnect the power cord and turn on the
system. If the indicator still flashes, or if the
cause of the problem cannot be found even after
checking all the above items, consult your
nearest Sony dealer.
General
The display starts flashing as soon as you
plug in the power cord even though you have
not turned on the system (see step 6 of
"Hooking up the system" (page 7)).
• Press DISPLAY twice while the system is off. The
demonstration disappears.
"– –:– –" appears in the display.
• A power interruption has occurred. Set the clock
(page 10) and timer settings (pages 29 and 30)
again.
GB
38
?/1 indicator stops flashing,
The clock setting/radio presetting/timer is
canceled.
• Redo the following:
– "Setting the clock" (page 10)
– "Presetting radio stations" (page 18)
– "Check the setting" (pages 30 and 31)
– "Timer recording radio programs" (page 30)
There is no sound.
• Press VOL +/– or turn VOLUME control on the
unit clockwise.
• Make sure the headphones are not connected.
• Check the speaker connections (page 7).
• There is no audio output during timer recording.
There is no microphone sound.
• Press VOL +/– (or turn VOLUME on the unit) or
turn MIC LEVEL on the unit to adjust the
microphone volume.
• Make sure the microphone is connected to the
MIC jack on the unit correctly.
Sound comes from one channel, or
unbalanced left and right volume.
• Place the speakers as symmetrically as possible.
• Connect the supplied speakers.
Sound lacks bass.
• Check that the speaker's + and – jacks are
connected correctly.
There is severe hum or noise.
• Move the system away from the source of noise.
• Connect the system to a different wall outlet.
• Install a noise filter (commercially available) to
the power cord.
The timer cannot be set.
• Set the clock again (page 10).
The timer does not function.
• Check the timer setting and set the correct time
(pages 30 and 31).
• Cancel the Sleep Timer Function (page 29).
The remote does not function.
• Remove the obstacle.
• Move the remote closer to the system.
• Point the remote at the system's sensor.
• Replace the batteries (R6/size AA).
• Locate the system away from the fluorescent light.
There is acoustic feedback.
• Reduce the volume.
• Move the microphone away from the speakers or
change the direction of the microphone.