Adjusting The Recording Level - Sony MDS-JE440 Operating Instructions Manual

• If "LPstamp On" is set, "LP:" is recorded as part of the track
name, so the number of characters that can be input in a single
MD is reduced. Furthermore, "LP:" is automatically copied if
the track name is copied or if the track is divided by using the
Divide function.
• MDs recorded in MD LP (LP2 or LP4 Stereo) mode should be
played back on a deck that supports MD LP mode. These MDs
cannot be played back on other decks.
• Even if you press REC MODE during recording or recording
pause, you cannot change the recording mode.
• Even if you press REC MODE repeatedly to select MONO,
the monitor signal during recording does not become
monaural.
16
Recording for long times/Adjusting the recording level
Adjusting the recording
level
You can adjust the recording level for both analog and
digital recordings.
1
Do steps 1 to 6 of "Recording to an MD" on
page 13.
2
Play the portion of the program source with the
strongest output.
3
Press LEVEL/DISPLAY/CHAR (or DISPLAY)
repeatedly until the level of the input signal
appears.
4
MDS-JE640
While monitoring the sound, turn AMS (or press
LEVEL +/– repeatedly) to raise the recording level
to its highest level without turning on the two
rightmost indicators on the peak level meters.
MDS-JE640
Avoid turning on these indicators
MDS-JE440
While monitoring the sound, turn AMS (or press
./> repeatedly) to raise the recording level to
its highest level without turning on "OVER" on the
peak level meters.
MDS-JE440
Avoid turning on these indicators
5
Stop playing the program source.
6
To start recording, continue from step 8 of
"Recording to an MD" on page 13.
z
You can adjust the recording level using the
Z
remote
During recording or recording pause, press LEVEL +/–
repeatedly.
AMS
AMS
LEVEL/DISPLAY/CHAR